CAUTIONRead all precautions and instruc-tions in this manual before usingthis equipment. Save this manualfor future reference.Model No. NTSA03991Seria
1016. Wrap the High Cable (73) around a 4” Pulley (35) inthe direction shown and attach the Pulley inside theTop Frame (1) with a 3/8” x 2 1/2” Bolt (
111313. Loosen the 1/2” Plain Nut (68) on the bolt at the endof the High Cable (73). Detach the bolt from the topof the Weight Tube (36) and the 5 7/8
1219. Attach the Backrest (134) to the Seat Frame (106)with four 1/4” x 3/4” Bolts (130).18. Open the parts bag labeled “SEAT ASSEMBLY.”Attach the Sea
13AdjustmentUsing the Leg Press AccessoryAdjusting the SeatTo adjust the position of the Seat Frame (106), unscrewthe handle of the Adjustment Knob (1
14Note: “#” indicates a non-illustrated part. Specifications are subject to change without notice. 101 1 Press Base102 1 Press Frame103 1 Base Support
151081071241201221201241241101131161221201181151121121241181171251181261201331271221151181181101131161201181201191231161131131211161181321321•01121311
Ordering Replacement PartsTo order replacement parts, simply call our Customer Service Department toll-free at 1-888-825-2588, Mondaythrough Friday, 6
2Warning Decal Placement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3WARNING:Before beginning this or any exercise program, consult your physician. Thisis especially important for persons over the age of 35 or persons
4Part Identification ChartRefer to the drawings below to identify small parts used in assembly. The number in parentheses by each draw-ing is the key
5AssemblyMake sure you have the following tools:• Two adjustable wrenches• One rubber mallet•You will also need grease or petroleum jelly, asmall am
62. Remove the inner cap and the four hole plugs fromthe end of the stabilizer.Attach the Base Support (103) to the stabilizer withtwo 3/8” x 2 3/4” B
74. Slide the Press Frame (102) through the Seat Frame(106). Press a 2” Square Inner Cap (112) into the indicatedend of the Press Frame (102). Press
810. Wrap the Cable (133) under a 4” Pulley (113) andattach the Pulley and a Cable Trap (116) to the BaseFrame (101) with a 3/8” x 3 3/4” Bolt (110),
913. Locate the Pulley Bracket (91), a 1/4” Flat Washer(71), and a 1/4” Nylon Locknut (25) that came withyour weight system. Attach the end of the Cab
Comments to this Manuals