NordicTrack 21917 Owner's Manual download pdf (Page 24)

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling,

even when the resistance is adjusted to the highest

level, the drive belt may need to be adjusted.

To adjust the drive belt, first unplug the power

adapter. Next, carefully tip the exercise bike onto its

left side as shown.

Using an M10 socket wrench with an extension (not

included), reach into the opening in the bottom of the

Right Shield (58) and tighten the M10 x 50mm Screw

(49) a few turns until the Drive Belt (not shown) is tight;

do not overtighten the Drive Belt.

Then, tip the exercise bike upright. Repeat this

process, if necessary, until the pedals no longer slip.

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to

computer or peripheral devices. Changes or modifications not expressly approved by the party respon-

sible for compliance could void the user’s authority to operate this equipment.

IMPORTANT: To satisfy exposure compliance requirements, the antenna and transmitter in the console

must be at least 8 in. (20 cm) from all persons and must not be near or connected to any other antenna or

transmitter.

Note: The console contains FCC ID: OMCBMDI.

1 2 ... 19 20 21 22 23 24 25 26 27 28

No comments

NordicTrack 21917 Owner's Manual Page 24