NordicTrack 25044 Owner's Manual download pdf (Page 12)

7. IMPORTANT: To avoid damaging the Pulse

Crossbar (93), do not use power tools and do

not overtighten the #10 x 3/4" Screws (9).

Orient the Pulse Crossbar (93) as shown. Attach

the Pulse Crossbar to the Handrails (86) with two

#10 x 3/4" Screws (9) and two #10 Star Washers

(5); start all four Screws, and then tighten

them.

Next, firmly tighten the four 5/16" x 2 1/2"

Screws (28).

Then, remove the wire tie (A) from the Upright

Wire (81).

6. Attach a Handrail (86) to the Right Upright (90)

with two 5/16" x 2 1/2" Screws (28) and two

5/16" Star Washers (11) in the location shown;

do not fully tighten the Screws yet. Make

sure not to pinch the Upright Wire (81), and

make sure that the wire is on the side of the

Upright as shown.

Attach the other Handrail (86) to the Left

Upright (89) in the same way. Note: There are

no wires on the left side.

Then, remove and discard the indicated screws

(E).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

No comments

NordicTrack 25044 Owner's Manual Page 12