www.nordictrack.comModel No. NTEL07808.1 Serial No.____________Write the serial number in the space above for reference.Serial Number Decal (on unders
10. Attach the Right Pedal Arm (58) to the Right Pedal Bracket (64) with two M10 x 45mm Patch Screws (99).Repeat this step for the Left Pedal Arm (44
12. Attach the Water Bottle Holder (37) to the Upright (4) with two M4 x 16mm Screws (104).13. While a second person holds the Console (7) near the Up
HOW TO USE THE ELLIPTICAL EXERCISERHOW TO PLUG IN THE POWER ADAPTER HOW TO MOVE THE ELLIPTICAL EXERCISERPlug one end of the included power adapter int
HOW TO EXERCISE ON THE ELLIPTICAL EXERCISERTo mount the elliptical exerciser, hold the handlebars and step onto the pedal that is in the lower positio
CONSOLE DIAGRAMENDURANCEPERFORMANCEiODSTIMEEEH I5LImtraînerWORKOUTS(pnt V AWORKOUTS at ¡FIT.COMSiLENT MAGNETIC RESISTANCEWEIGEHT LOSS 2WElGFiT LOSS 3W
1. Begin pedaling or press any button on the console to turn on the console.A moment after you begin pedaling or press a button, a tone will sound,
5. Measure your heart rate if desired.If there are sheets of clear plastic on the metal contacts on the handgrip pulse sensor, remove the plastic. To
1. Begin pedaling or press any button on the console to turn on the console.A moment after you begin pedaling or press a button, a tone will sound,
1. Begin pedaling or press any button on the console to turn on the console.A moment after you begin pedaling or press a button, a tone will sound,
HOW TO USE AN IFIT WORKOUT HOW TO USE THE SOUND SYSTEM¡Fit cards are available separately. To purchase IFIt cards, go to www.iFit.com or see the front
TABLE OF CONTENTSWARNING DECAL PLACEMENT...
HOW TO CHANGE CONSOLE SETTINGS 3. Select a unit of measurement if desired.The console features a user mode that allows you to select a unit of measure
MAINTENANCE AND TROUBLESHOOTINGInspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.To clean the el
EXERCISE GUIDELINESA WARNING: Before beginningthis or any exercise program, consult your physician. This is especially important for persons over the
PART LIST--Model No. NTEL07808.1R1208AKey No.Qty. DescriptionKey No.Qty. Description1 1Frame 512 Roller2 1Base52 2Pedal Arm Cap31 Ramp53 8 Axle Cover4
Key No.Qty.Description Key No.Qty. Description1012 M8 X 20mm Washer Ill 1Lower Wire Harness102 12 M8 Locknut 112 1 Power Adapter1031 M3.5 X 12mm Flat
EXPLODED DRAWING A--Model No. NTEL07808.1R1208A
EXPLODED DRAWING B-Moúe¡ No. NTEL07808.1R1208A
EXPLODED DRAWING C-Model No. NTEL07808.1R1208A27
ORDERING REPLACEIVIENT PARTSTo order replacement parts, please see the front cover of this manual. To help us assist you, be prepared to provide the f
IMPORTANT PRECAUTIONSAwarning I To reduce the risk of serious injury, read ail important precautions and instructions in this manual and all warnings
BEFORE YOU BEGINThank you for selecting the new NordicTrack® E7 SV FRONT DRIVE elliptical exerciser. The E7 SV FRONT DRIVE elliptical exerciser provid
ASSEMBLYAssembly requires two persons. Place all parts of the elliptical exerciser In a cleared area and remove the packing materials. Do not dispose
1.2. Orient the Ramp (3) as shown. Then, insert the Ramp into the Frame (1).Attach the Ramp (3) with five M8 x 19mm Patch Screws (82) and five M8 Spli
4. Apply a small amount of the Included grease to the right Crank Arm (20) and to a 19mm Wave Washer (66).Slide a Crank Arm Spacer (55) and the 19mm
6. Identify the Right Handlebar (61) and the Right Handlebar Leg (60), which are marked with “Right” stickers, and orient them as shown. Make sure th
8. Attach an Outer Handlebar Cover (67) and the Inner Handlebar Cover (68) around the Right Handlebar Leg (60) with two M4 x 16mm Screws (104).Repeat
Comments to this Manuals