Nordictrack C2270 NTL12950 User Manual download pdf (Page 8)

If you have purchased an optional chest pulse sensor,

follow step 6 to install the receiver included with the

chest pulse sensor. If you have not, go to step 7.

6. Place the console assembly face-down. Be careful not to

scratch the face of the console. Remove the indicated

3/4” Screw (7) and the Access Door (95) from the left side

of the Console Back (96).

Connect the wire on the receiver (A) to the indicated wire

extending from the Console Back (96). Hold the receiver

so the small cylinder is oriented as shown and is fac-

ing the Console Back. Attach the receiver to the plastic

posts on the Access Door (95) with the two included small

screws.

Make sure that no wires are pinched. Reattach the

Access Door (95) with the 3/4” Screw (7). Discard the

other wires included with the receiver.

Small

Cylinder

Wire

Small

Screws

7. Cut the tie securing the wires to the Upright Base (85).

Have a second person hold the console assembly near the

Upright Base. Connect the Upright Wire Harness (73) and

the Pulse Wire (74) to the wires extending from the console

assembly. The connectors should slide together easily

and snap into place. If they do not, turn one connector

and try again. Insert the connectors into

the console as

sembly. If necessary, remove the right accessory tray (not

shown) from the console assembly.

Connect the Upright Ground Wire (113) to the ground wire

extending from the console assembly. Make sure that the

wires are fully inserted into each other. I

nsert the ground

wires into

the console assembly. Reinsert the right acces

sory tray (not shown) into the console assembly if neces-

sary.

Console

Assembly

Ground

Wire

113

5. Cut the tie securing the Pulse Wire (74) to the Upright

Base (85). Hold the Pulse Bar Assembly (69) near the

crossbar on the Upright Base (85). Connect the Pulse

Wire to the wire in the Pulse Bar Assembly.

The connec-

tors should slide together easily and snap into place.

If they do not, turn one connector and try again. Insert

the wires into the crossbar.

Open parts bag B. Attach the Pulse Bar Assembly (69) to

the crossbar on the Upright Base (85) with four Pulse Bar

Bolts (127) and Star Washers (67). Start all four Pulse Bar

Bolts before tightening them. Make sure that no wires

are pinched.

127

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Comments to this Manuals

No comments

Nordictrack C2270 NTL12950 User Manual Page 8

Comments to this Manuals

Related products and manuals for Sports and recreation Nordictrack C2270 NTL12950